Remote Management SystemForFMX TransmittersUser’s Manual©2002 Crown Broadcast, a division of International Radio and Electronics, Inc.25166 Leer Drive
Revision 2.0RMS User’s Manual2—22.1 Before You InstallBefore you begin installing the RMS, take time to review the following connector information:• S
Revision 2.0Installation2—32.1.2 Controls and IndicatorsAnalog Gain Use to trim the analog input.Status Indicators A display of conditions and states
Revision 2.0RMS User’s Manual2—42.1.3 Auxiliary Equipment ConnectionsConnections between the RMS and auxiliary equipment are made at a row of removabl
Revision 2.0Installation2—52.2 Installing the RMSInstallation procedures vary with the model on which you are installing the RMS. Choose the appropria
Revision 2.0RMS User’s Manual2—63. Position RMS module inside the mounting bracket. Replace end screws and washers.4. Continue in Section 2.3, Place i
Revision 2.0Installation2—72.2.2 Installing RMS module on FMX100 and FMX250 transmittersFollow the transmitter shut down procedures. Note the position
Revision 2.0RMS User’s Manual2—84. Position RMS mounting bracket over the four studs on the adaptor bracket. Fasten with nuts and lock washers.5. Fast
Operation 3—1Section 3—OperationThis section provides general operating parameters of your Remote Management System and a detailed description of its
Revision 2.0RMS User’s Manual3—23.1 IntroductionThe RMS operates in three remote modes. Each mode is described in the following sections.• Section 3.2
Revision 2.0Operation3—31 1 *Channel #11, Digital In 1 Hi/Lo1 2 *Channel #12, Digital In 2 Hi/Lo1 3 *Channel #13, Digital In 3 Hi/Lo1 4 *Channel #14,
RMS User’s ManualiiRevision ControlRevision Print DateRevision 2.0 March
Revision 2.0RMS User’s Manual3—43.3 Automatic Call outYou may program the RMS to call a telephone number and give you an alarm report when triggered b
Revision 2.0Operation3—53.4 Remote Control CommandsUse the RMS remote control commands to access the FMX transmitter settings menus as well as the ext
Revision 2.0RMS User’s Manual3—63.4.2 FMX/RMS Audio MonitoringThe RMS unit can monitor a variety of audio sources available from the FMX DMS as well a
Revision 2.0Operation3—73.4.3 Relay CommandsThe following commands control the settings of the relay contacts on the back of the RMS.5Output Relay Con
Revision 2.0RMS User’s Manual3—8
Revision 2.0Service and Support4—1Section 4—Service and SupportWe understand that you may need various levels of support or that the product could req
Revision 2.0RMS User’s Manual4—24.1 ServiceThe product warranty (see opposite page) outlines our responsibility for defective products. Before returni
Revision 2.0Service and Support4—3Three-Year Limited WarrantyNorth America OnlySUMMARY OF WARRANTYWe, Crown Broadcast, a business unit of Internationa
Revision 2.0RMS User’s Manual4—4Factory Service InstructionsTo obtain factory service, complete the bottom half of this page, include it with the unit
Revision 2.0A-1Appendix A—Pin Assignment Worksheet The following worksheets provide both the pin descriptions, RMS commands and an area to record conn
Revision 2.0iiiTable of ContentsSection 1—Getting Acquainted1.1 Description...
Revision 2.0RMS User’s ManualA-2A.2 Digital status inputs Use the digital status inputs to monitor signals which can be represented as either an on or
Revision 2.0A-3A.3 Analog status inputUse the analog status inputs to monitor a signal which can be converted to a range of 0 to 12 volts DC. Use the
Revision 2.0RMS User’s ManualA-4A.4 Relay contactsUse relay contacts to control auxilary equipment. See Section 1.2, Specifications, for relay contact
Revision 2.0RMS User’s Manualiv
Revision 2.0Getting Acquainted1—1Section 1—Getting AcquaintedThis section provides a general description of the Crown Broadcast Remote Management Syst
Revision 2.0RMS User’s ManualI1—21.1 DescriptionThe Crown Broadcast Remote Management System (RMS) is an option for the Crown Broadcast Digital Manage
Revision 2.0Getting Acquainted1—31.2 Specifications System Compatibility Crown FMX30, FMX100 and FMX250 series transmitters.Telephone Access Dial-up t
Revision 2.0RMS User’s ManualI1—41.3 Safety ConsiderationsCrown Broadcast assumes the responsibility for providing you a safe product and safety guide
Installation 2—1Section 2—InstallationThis section provides important guidelines for installing your Remote Management System. Review this information
Comments to this Manuals