Crown DSi Series Instruction Manual download pdf (Page 5)

Operation Manual

DSi 8M Cinema System Monitor

page 8 page 9

DSi 8M Cinema System Monitor

Operation Manual

3 Installation

3.1 Materials Required

You will need to supply the following materials:

• Shielded audio cable for connecting the DSi 8M to the

cinema processor and power ampliﬁer inputs

• Twisted wire for connecting the DSi 8M to non-DSi power-

ampliﬁer outputs

• Four 10-32 x 1/2” screws to mount the DSi 8M in the

audio equipment rack

• Small standard screwdriver

• No. 2 Philips screwdriver

• Wire strippers

3.2 Mount the DSi 8M

The ideal place for the DSi 8M Monitor Panel is in the sound

rack or projector console between the stereo proces sor and

power ampliﬁers. DB25 and HD15 connectors are available

on the back panel to make installation quick and easy.

Alternatively, terminal blocks allow the use of stripped and

tinned wire. They are pluggable for easy service and

troubleshooting.

3.3 Monitor Wiring

1. Connect to AC Power.

Connect the unit to the AC power outlet using the

stan dard IEC cable provided. Any power source from

100-240V , 50-60 Hz will be sufﬁcient. Plug the

Modular Power Supply into the Bypass Power input and

into a power source that matches the Modular Power

Supply requirements.

(continued)

L Biamp

C Biamp

R Biamp

Sw Amp

LS/RS Amp

Bsl/Bsr Amp

CINEMA PROCESSOR

MAIN AUDIO

OUTPUTS

OPTION CARD I/O

DB-25

CABLES

DSi-8M

DSi POWER AMPLIFIERS

VGA

CABLES

Figure 3.1 Wiring DSi 8M Monitor Panel to DSi Ampliﬁers

3 Installation (continued)

2. Connect cinema processor output to DSi 8M input.

See Figure 3-1. Use the male-female 25-pin D cable to connect the

output of the cinema processor to the Main input of the DSi 8M. If

“EX” channels are to be used, plug an additional male-female 25-pin

D cable from the Optional Outputs at the processor to the Optional

Inputs of the DSi 8M.

3. Make DIP switch settings.

Ls/Rs in Main Connector: Set switches 1-4 ON, 5-8 OFF.

Ls/Rs in Optional Connector: Set switches 5-8 ON, 1-4 OFF.

USL JSD-80 processor using:

Bsl/Bsr in Main Connector: Set switches A-D ON, E-O OFF.

Lc/Rc in Main Connector: Set switches A-O OFF.

Lc/Rc and/or Bsl/Bsr in Optional Connector: Set switches E-H ON,

A-D OFF, J-O OFF.

Dolby

CP-650 processor using:

Le/Re in Optional Connector: Set switches E-H ON, A-D OFF, J-O

OFF.

Lm/Cm/Rm in Optional Connector: Set switches J-O ON, A-H OFF.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Crown DSi Series Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Supplementary music equipment Crown DSi Series

Prodotti e manuali riguardandi Scheda madre Asus P7H55D-M PRO