Crown POWER-TECH 3 Owner's Manual download pdf (Page 5)

English

Installing the Spikes

The M2 is shipped with four rubber feet attached to the bottom of the enclosure for use when the

speaker is installed upright on a hard surface. Four pointed spikes are included that allow the speaker to

acoustically decouple from the ﬂoor when it is installed upright on a carpeted ﬂoor.

WARNING: The spikes are extremely sharp. Use caution when handling them.

If you wish to use the spikes when installing the speaker on a hard surface, place

coins or similar items under the spikes to prevent damage the ﬂoor surface.

When moving the speaker with the spikes attached, never slide it along the ﬂoor, as this can damage the ﬂoor,

the spikes or the speaker itself. Lift the speaker and carry it to its new location.

When using the spikes, do not remove the rubber

feet from the speaker. To install the spikes, position

the speaker on a carpeted or padded surface. Insert

the threaded end of the spike into the aperture of the

rubber foot. Turn the spike in a clockwise direction and

continue until the spike is inserted as far as it will go.



1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Crown POWER-TECH 3 Owner's Manual Page 5