Crown QMS Setup Guide download pdf (Page 18)

Network

Connection

QMS CrownNet Setup Guide16

b Once the printer is on line and the message window reads

IDLE, press the Online/Offline key to take it off line.

c Access the Administration/Communications/

xxxxxxxx

NIC/

CrownNet/Common/Ring Speed menu (where

xxxxxxxx

either Resident or Optional).

» Note:

For complete information on using the control panel,

see your printer documentation.

d Select 4 Mbits/Sec as the network speed.

▲ Caution:

Leave the printer disconnected from the network if

you are changing the ring speed.

e Use the Administration/Communications/

xxxxxxxx

NIC/

CrownNet/Common/Soft Reset menu to reset the CrownNet

interface (where

xxxxxxxx

is either Resident or Optional).

f Connect the printer to the network with the network adapter

cable.

5 The default source routing type (Auto—Send the file as the

most appropriate frame type) is fine for most Token-Ring net-

works.

However, if your network uses a different type of source routing,

identify that now in the Administration/Communications/

xxxxxxxx

NIC/CrownNet/Common/Source Routing menu (where

xxxxxxxx

is either Resident or Optional). Other choices are

n All—Send as an all-routes-explorer frame, also known as an

all-routes-broadcast frame.

n Off—Send without source routing information.

n Single—Send as a spanning-tree-explorer frame, also

known as a single-route-broadcast frame.

6 Go to “Software Installation” on page 17.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 85 86

No comments

Crown QMS Setup Guide Page 18