Before you begin using your Pocket Blender, you will need to have a pickup and microphone in place on your instrument.
Here are four common scenarios:
WARNING: INSTALLATION BY A QUALIFIED PROFESSIONAL REPAIRMAN IS STRONGLY RECOMMENDED.
FISHMAN TRANSDUCERS WILL NOT BE RESPONSIBLE FOR ANY DAMAGES TO YOUR INSTRUMENT DUE TO IMPROPER INSTALLATION.
FISHMAN POCKET BLENDER
PREPARING YOUR INSTRUMENT
3
PASSIVE PICKUP
AND MICROPHONE:
If your instrument has a passive
piezo pickup, it’s easy to connect
it and a microphone to the same
stereo endpin jack. Connect the
pickup to tip, and the microphone
to ring.
PICKUP WITH
POWERJACK AND
MICROPHONE:
If your instrument has a piezo or
magnetic pickup and a Fishman
Powerjack, connect a microphone
to the ring by soldering it to the
appropriate terminal on the
Powerjack circuit board.
ACTIVE PICKUP
AND MICROPHONE:
If your instrument has an active piezo
pickup - such as the Fishman Acoustic
Matrix - you will need a Fishman
Smart Switch to connect a microphone
to the stereo endpin jack for the sys-
tem to operate. See Page 23
PICKUP AND MICROPHONE
WITH SEPARATE MONO INSTRUMENT CABLES:
You may choose to route the pickup and microphone
through two separate mono instrument cables.
You will need a stereo "Y" cable (available from Fishman).
Comments to this Manuals